Quantcast

Planning For Radon Mitigation – Simple DIY Project

0

The prevalence of Radon Gas in the soils in areas around the United States is an issue of growing concern. Radon has been deemed the number 1 cause of lung cancer in non-smokers in a study done at the University of Iowa. Radon gas is found in varying levels in almost all regions of the country.

Radon Risk In Your County

\\"Radon

Radon Map Zone areas in pink pose the highest risk followed by Orange and Yellow. Click here to check the specific Radon risk level in your county.

Radon Zone Map

Radon Zone Map

Areas in red have the highest potential exposure, Orange second and Yellow, the lowest potential, but all araas in the US can have isolated pockets of varying exposure.  The EPA recommends that all homes should be tested.  If your home building project is in an area of higher risk, you should plan early to install a Radon Mitigation System. In many areas now, a test is required with each real-estate transaction regarding residential properties and this will probably expand to include most of the higher risk areas. In any event, your health is well worth the small investment to install such a system.

Active And Passive Radon Venting Systems

Installing the basics of the system in a Basement foundation or Slab-On-Grade Foundation consists of inserting a perforated pipe below the slab in crushed rock and stubbing up a connector into the basement. Venting this pipe to the exterior (away from any windows in your house or your neighbors, preferably up through the roof), contitutes what is known as a Passive Radon Mitigation System. If , after your house is complete, a test determines that levels are still too high, you may have to convert to an Active Radon Mitigation System by installing a fan than runs continuously which creates low pressure under the slab and increases the rate of gas evacuation.

This video explains one method of actively venting through the garage of an existing home:

So you will want to have the slab penetration in an area that is readily accessible and has electric available to power the fan. There is a new option called Form-A-Drain, which is a PVC system that functions as a concrete form, hydrostatic water drain and radon venting system all in one.

Many times the fan is located in the attic, particularly if your foundation is slab-on-grade or crawl space. Also remember that you will want to make sure that the vent through the roof does not allow water to fall down the pipe to the slab below, this would not be a good thing for several reasons.

Designing and installing the infrastructure for a passive system can be accomplished for about $250 to $350 in a typical new home. This will save you 400-500% of the cost of retrofitting. An active system will add $450-$750 depending on the size of your hew home.

Download an 84 page  guide on the design and construction of Radon Mitigation Systems.  It is free for registered users of the site. Enter your e-mail address in the “Enews and Updates” box in the top right hand column to register.  We do not share your address with anyone outside of DIY Green Home Improvement or Archeon, Inc.  Once you have registered, go to the download page and download your copy of “Design Radon Out”.

Related items

Popularity: 42% [?]

Share and Enjoy:
  • Print this article!
  • Digg
  • del.icio.us
  • Facebook
  • Mixx
  • Google Bookmarks
  • Diigo
  • Turn this article into a PDF!
  • Reddit
  • StumbleUpon
  • Twitter
  • Yahoo! Buzz
Tweet This

Speak Your Mind

Tell us what you're thinking...
and oh, if you want a pic to show with your comment, go get a gravatar!

Spam Protection by WP-SpamFree

Improve the web with Nofollow Reciprocity.